6.3" LS063R1SX01 1440X2560 LCD Screen with H-D-compatible Board for 50pin MIPI tft lcd Screen lcd screen

LCD Controller Board:

H-D-compatible Board Work for 50Pin Mipi LCD Screen

Input Power Adapter: 5Vdc More than 1A.

Come In Standby Model When Not Input Signal

Standby Model <0.3W

Audio Input:H-D-compatible

Board Size: 65mm x 64mm x 3mm

6.3"LS063R1SX01 1440X2560 TFT LCD Screen With Backlight:

Display New Mode2, Normally Black, Transmissive

Resolution 1440(RGB)×2560

Outline Size 80.84×148.92×1.58(H×V×D)

Display Area 78.84× 140.16 (H×V)

Brightness 400 cd/m² (Typ.)

Contrast Ratio 1300:1 (Typ.) (TM) 

Viewing Angle 80/80/80/80 (Typ.)(CR≥10) [Left / Right / Up / Down]

Signal Interface MIPI (2 ch, 4 data lanes) ,60 pins , Connector

Backlight WLED

Input Voltage 1.8/5.75/-5.75V (Typ.)(IOVCC/VSP/VSN)

Packing list :

1× H-D-compatible To Mipi LCD Controller Board VS-HDMITMIPI-V1 60Hz

1× 6.3inch LS063R1SX01 1440X2560 LCD Screen

1× Signal Cable

1× Converter Board

Instruction:

1. When H-D-compatible signal is not accept. It shows black Image and LED flashing on main board. Please change HDMI source for test.

2. When H-D-compatible accept. It shows correct image and LED is blue.

This Board work with PC and Raspberry Pi. The image not support Scaling. It shows image depend on HDMI input source.

Turn On：

a、Connect Converter Board With LCD Screen Interface

b、Connect Converter Board With 60Pin Cable

c、Connect Main Board With 60Pin Cable

d、Insert H-D-compatible Type Cable

e、Turn On 5Vdc or USB as Power Supply 

Turn Off：

a、Turn Off 5Vdc or Remove USB Power Adapter

b、Remove H-D-compatible Cable

c、Disconnect Main Board With 60Pin Cable

d、Disconnect Converter Board With 60Pin Cable

e、Disconnect 60Pin Cable With LCD Screen

For PC:

1. Most of MIPI screen for vertical display. Need to adjust computer graphics mode.

2. Replication Mode - Extended mode - Vertical and Horizontal adjustment.

For Raspberry Pi

1. The Main Board Four Locating Holes Compatible With Raspberry Pi.

2. Different Raspberry Pi are set differently. Please connect with Raspberry Pi Technical support.